Software Gateway Method - Device Configuration
By enabling the "Private Deployment Hotspot" at the device location, the device will send private deployment configuration requests (e.g., interface requests) to the server after connecting to the hotspot, and save the configuration information returned by the interface.
The Private Deployment Hotspot method can not only configure private deployment settings but also perform network configuration for the device simultaneously. Ensure the Software Gateway is running properly before configuration.1. Software Gateway Configuration
Go to the settings page of the Software Gateway and enter the on-site WiFi network information.
2. Enable Private Deployment Hotspot
Please enable a 2.4G wireless hotspot at the device location:
Hotspot Name:
pvt-IP-Address-PortHotspot Password:
unisoft.cn [Fixed]
1. After enabling the hotspot, restart the device. The device will scan for the "Private Deployment Configuration Hotspot" in nearby networks.
2. Once the hotspot is detected, the device will connect to it and save the relevant gateway information.
3. If you have configured the on-site network on the Software Gateway, the device will start attempting to connect to the on-site network.
2. Once the hotspot is detected, the device will connect to it and save the relevant gateway information.
3. If you have configured the on-site network on the Software Gateway, the device will start attempting to connect to the on-site network.
3. Check Device
Devices that have been successfully configured will be displayed on the device list page of the Software Gateway.